Pack of 25 - 1" - Official Breast Cancer Ribbon Patch - Flexstyle® Metallic Pink - Heat Applied Backing

Emblem Sizes

• 1”
• 2"

Available Colors

• Pink (Breast cancer)
• Red (Blood cancer)
• Yellow (Bone cancer)
• Purple (Pancreatic cancer)
• Blue (Colon cancer)

Backing

• Heat applied heat seal
• Pressure-sensitive

Limitations

• Heat applied – Not recommended for use on materials that may be heat sensitive (e.g., some nylons, silk, some plastics, leather, wool, fleece, etc.) or for weather-treated materials due to chemicals used that do not allow the emblems to adhere properly.
• Pressure-sensitive – Recommended for flat, non-textured surfaces including glass, plastic, wood, and metal. Not recommended for surfaces with an oil finish (e.g., silicon, Teflon™), rough fabrics, or outdoor goods.

Washing Information

• FlexStyle® emblems will withstand at least 52 domestic washing machine cycles at 104°F max.

Shelf Life

• One-year shelf life before applying (room temperature-controlled environment).

Pressure-Sensitive

1. Use rubbing alcohol to thoroughly clean the application area.
2. Remove paper backing and press emblem firmly on desired location.
3. After applying pressure, peel the clear top carrier from the emblem.

Heat Applied Backing with a Top Heat Press - Garments

1. Set the press at 350-360°F for top heat with 40-60 psi of pressure.
2. Place garment on the heat press with the FlexStyle® Silicone Pad on top and press for 20 seconds to preheat the garment.
3. Place the FlexStyle® on the garment in the desired location. Place the FlexStyle® Silicone Pad over the design.
4. Press for 12-15 seconds.
5. Remove the garment shirt from the heat press and remove the clear cover once cooled.

Heat Applied Heat Seal on Hats - Using the 360 IQ™ Hat Heat Press

1. Set the press at 280°-300°F for top heat and 280°-300°F for bottom heat with 40-60 psi of pressure.
2. Place the hat on the heat press, leaving out the inner layer of the cap. Use the adjustment lever for a better grip.
3. Place the emblem on the desired location. To secure the emblem and prevent it from moving, use Thermal Tape.
4. Place a FlexStyle® Silicone Pad over the design.
5. Press for 10-12 seconds.
6. Deactivate the adjustment lever and remove the hat from the heat press.
7. Remove the Thermal Tape and the clear cover once the emblem has cooled.

Disclaimer

World Emblem recommends testing the best combination of heat seal parameters before application. World Emblem is not liable for any damages to garments during the application process.

Note: Please check out www.youtube.com/worldemblem for step-by-step instructions for applying our apparel decorations.

World Emblem FlexStyle® Ribbons are in-stock products that can be shipped out the same day, if ordered before the daily cut-off time.