Faux Leather Laserable Sheets

Sheet Size

24" x 12"

Colors

• Black/Silver
• Chestnut/Black
• Chocolate/Black
• Sandstone/Black

Backing

• Heat Applied
• Peel & Stick

Limitations

Heat Applied - Recommended application for thicker materials, such as jackets, and hats that can withstand a heat press and 320° F. Not recommended for use on materials that may be heat sensitive (ex: some nylons, silk, some plastics, leather, wool, fleece, etc.) or for weather-treated materials, due to chemicals used that do not allow the emblems to adhere properly.
Peel & Stick  - Recommended application is on flat, non-textured surfaces, including glass, plastic, wood, and metal. Not recommended for application on surfaces that may contain an oil finish, such as silicon, Teflon™, rough fabrics, or outdoor goods.

Washing Information

Faux Leather will withstand at least 52 domestic washing machine cycles at 104°F max.

Shelf Life

One year shelf life before applying (room temperature-controlled environment).

Peel & Stick

1. Use rubbing alcohol to thoroughly clean the application area
2. Remove paper backing and press emblem firmly on desired location
3. After applying pressure, peel the clear top carrier from the emblem

Heat Applied Backing with a Top Heat Press - Garments

1. Set press to 315-325°F for top heat with 70-80 psi of pressure.
2. Ensure application location is wrinkle-free and place garment onto press.
3. Place patch onto desired location on garment. Thermal Tape is optional.
4. Over a FlexStyle® Silicone Pad, turn around garment and load into the heat press.
5. Press for 12-18 seconds.
6. Remove garment from press and allow to cool.

Heat Applied Heat Seal on Hats - Using the 360 IQ™ HAT HEAT PRESS

1. Set press to 245°-255°F for top heat and 315°- 320°F for bottom heat with 60-80 psi of pressure.
2. Place hat on heat press, leaving out the inner layer of the cap. Use adjustment lever for a better grip.
3. Place emblem onto desired location. To secure the emblem and prevent it from moving, use Thermal Tape.
4. Place a FlexStyle® Silicone Pad over the design.
5. Press for 10-15 seconds.
6. Deactivate the adjustment lever and remove the hat from the heat press.
7. Remove Thermal Tape once the patch has cooled.

Disclaimer

World Emblem recommends testing the best combination of heat seal parameters before application. World Emblem is not liable for any damages to garments during the application process.

Note: Please check out www.youtube.com/worldemblem for step-by-step instructions for applying our apparel decorations.

Peel & stick Backing - $22.49 per sheet

Heat applied Backing - $17.52 per sheet